Do you want to get rid of those annoying lights on your refrigerator?
If yes then here’s a solution for you!
In this article I explain you how to replace the light bulbs on your Whirlpool fridge with LED lights.
This way you won’t need to worry about changing the bulb anymore.
I hope you enjoyed reading my article and if you did please give me a thumbs up and subscribe to my channel!
Whirlpool Refrigerator Led Lights Not Working
Whirlpool refrigerator led lights not working is a common problem faced by many people. It happens because of improper installation of the light bulbs. First check whether the bulb is properly installed or not. If it is not properly installed, replace it immediately. If the bulb is properly installed but still not working, try changing the bulb. If the bulb is still not working, contact the service center.
Device is on Sabbath mode
If the device is on Sabbath mode, please turn off the device and restart it. Device is out of warranty period
Refrigerator Door has been kept open for a longer time
Please check if the door is properly closed and locked. If not, please contact our customer service team immediately.
If you see any light switch, please turn off the power supply from the main panel. Then, please reset the switch to normal position.
Connection of the Wiring Harness
1 Please check whether the wiring harness is connected properly. 2 Please check whether the battery voltage is correct.
Faulty LED light
1 Please check whether you have installed the right fuse box. 2 Please check the fuse box circuit diagram.
Step 3: After pressing the reset button, press and release the "power" button located on the front left side of the refrigerator. How to program the freezer?
How do I reset my control panel on my fridge?
Step 1: Turn the power switch on to the "on" position. Step 2: Press and hold the "reset" button on the top right side of the refrigerator for about 10 seconds.
1. Press the power switch located on the front panel of the refrigerator. 2. Press and hold the "Reset" button until the display changes from "Off" to "On." 3. Release the "Reset" Button. 4. Press the power switch again to turn the unit off. 5. Plug the unit back into the outlet. 6. Open the door. 7. Enjoy!
To reset the controls on your refrigerator, follow these steps: 1 Turn off the refrigerator 2 Remove the door 3 Unplug the refrigerator 4 Wait about 10 minutes 5 Plug the refrigerator back into the wall 6 Close the door 7 Reset the controls 8 Reopen the door 9 Enjoy!
How do I reprogram my Whirlpool refrigerator?
You can press the power button located on the front of the unit to turn off the appliance. Pressing the power button again turns the unit back on. To change the setting, press and hold the buttons until the display changes from “off” to “on”. Once the display explains “on”, you can select any of the options available.
How do I reset the control panel on my Whirlpool refrigerator?
Question: Where is the reset button on my refrigerator?
How do I reset my refrigerator to factory settings?
If you own a refrigerator, chances are you know how to operate it. But if you’re not sure how to turn on the lights, adjust the temperature, or even open the door, here’s what you need to know about your refrigerator’s controls. First, check the manual. Most fridges have a manual that tells you how to operate the unit. If you can’t locate the manual, call customer service. Customer service representatives are usually available 24 hours a day, seven days a week. Ask them how to access the manual. Once you get the manual, read it carefully. It will tell you everything from how to operate the light switches to how to program the timer. Also, pay attention to any warnings or safety instructions. For instance, if the manual says that the compressor should only be operated during off-peak hours, follow those instructions. Finally, after reading the manual, practice using the controls. This will help you become familiar with the buttons and knobs.