Do you have issues with your DIRECTV Genie not working in one room?
If yes, then this article might help you out.
If you have been experiencing problems with your DIRECTV Genie, then this article might be able to help you out.
Why DIRECTV Genie Not Working in One Room
If you are having problems with DIRECTV Genie not working in one room, try these steps below: 1 Make sure that the remote control is turned off. 2 Turn off the TV and wait 5 minutes.
Check for the power connection
If you are not getting any output from your device, check if the power supply is connected properly. Also try connecting another power source to see if the problem persists. Restart your device
Inspect a Stable Network Connection
If you are still facing issues after following these steps, please contact our support team via email [email protected] or call us at +1 800 783-6388.
Check for HDMI Issues
Please check if your TV supports HDMI input. In case it does not, you can connect your TV directly to your PC using VGA cable. Check for Power Supply Issues
Check for any obstacle
If you see any power supply issue, please contact our customer service team immediately. Check for HDMI issues
Restart the TV and main DVR
If you still cannot resolve the problem, please call us directly.
Inspect the remote
Please check whether the remote is damaged. Please refer to the following picture. Check if the batteries are charged
Where is the DirecTV wireless video bridge?
You need to remove the screws from the backside of the TV stand and pull off the plastic piece that holds the wires together. Then you can take the two antennas apart and put them back together again.
How do I fix my DirecTV wireless bridge?
It’s located under the tv stand. How to connect the antenna wire to the wireless bridge? Answer: It’s located on the back side of the tv stand.
Why is one of my directv boxes not working?
1 Turn off the power supply 2 Remove the antenna from the tv set 3 Connect the antenna cable to your wireless bridge 4 Press the "setup" button on the wireless bridges 5 Select the channel using the remotes 6 Press the "ok" button on the wirelessbridges 7 Press the "enter" key 8 Wait until the tv powers on 9 Enjoy reading live TV!
[su_youtube_advanced url = "https://www.youtube.com/watch?v=F5UsoFjncUQ" controls = "no" rel = "no" fs = "no" modestbranding = "yes"]
How do I setup my DirecTV wireless bridge?
To setup your DirecTV wireless bridge, follow these steps: 1 Turn off the power supply to the TV set 2 Remove the antenna from the TV set 3 Connect the antenna cable to the wireless bridge 4 Press the "Setup" button on the wireless bridge 5 Select the channel using the remote control 6 Press the "OK" button on the wireless bridg 7 Press the "Enter" key 8 Wait until the TV set powers on 9 Enjoy reading live TV! How to access channels on the TV?
What does orange light mean on Direct TV box?
Directv Wireless Video Bridge is located under the TV cabinet. How to access the remote control? Answer: Remote Control is located on the back side of the TV cabinet.
Where is the directv wireless video bridge?
Orange light indicates that the box is receiving a signal from the satellite. It could be because the dish is dirty or the coaxial cable is damaged. Try cleaning the outside of the dish and check if the coaxial cable is connected properly.
How do I fix my directv wireless bridge?
If you are having problems with your Direct TV box, try resetting it. This usually fixes the problem. To reset your box, press and hold the power button for about 10 seconds. Then turn off the power completely and wait until the light turns green again. Press the power button again and the box will restart.