Is your nutrient trapped? Here’s how to fix it. Please be assured that you are not alone. We will tell you how to fix this problem.

If you notice that the knives are jamming and you smell like burnt wire, disconnect the nutrient ball immediately. Let cool for at least an hour. If it is unpacked and cooled, it will be reset. After that, it should work normally. Always try not to use Nutribullet for more than a minute.

There are other ways to trap a nutrient ball and we’ll show you how to solve each case.

Nutrient activators are trapped

If you find that your activators are stuck, there is a quick and easy solution. You usually notice this when you try to attach a file or pitcher, it just doesn’t match.

There is a quick, easy and convenient solution for this. This usually happens when the bond becomes unusable over time. It’s very easy to organize.

You will need a cotton cloth, alcohol, and a butter knife. The first step is to soak a cotton cloth in alcohol. Wipe the activators with a cotton cloth. The alcohol will begin to dissolve anything that might make you sticky.

Now take the knife and place it on the edge of the perimeter so that the tip of the knife touches the activator.

Press down on the plate and use the circuit as a lever while pressing the tip actuator downwards. This will solve your problem.

If it is still stuck, add a little more alcohol and repeat the same procedure. You have to release the activators. Save the cup or decanter and test. It should be closed.

Nutriled does not support

As we saw in the previous section, this could be due to activator blocking. There is one more simple reason to kick yourself.

The lip ring sometimes falls into an opening in the base where a decanter or cup can be closed. This is sometimes hard to see because the color looks like inside. It is very easy to solve. All you need to do is take your fork, slide it in, and take off the ring.

How to avoid blocking nutrient activators?

The main reason for activators to get stuck is because juices, smoothies or soups are leaking out. This is very easy to avoid. When placing your items in a cup or carafe, pay close attention to the way you cover them.

Place the cap on the cup and slide it so it rotates when closed. When it stops, turn it slightly to lock it in place. When turned, you will hear a beep.

This sound means it is properly closed and closed. Leaking outside is usually the cause of the leak. Swush, twist and twist and you’re done.

The file is connected to the power base

This is a common problem that most people grapple with, but is easily fixed. This can be done in four easy steps. First of all, you need to disconnect the device.

Second, you need to return the entire device with the file attached. While the whole unit is still upside down, the third step is to gently tap the bottom of the cup several times on the table top. The final step is to turn the cup in the opposite direction and it should come out immediately.

Removal of a blocked nutriplet plate

Assembly The blade assembly is the same part that functions as the conditioner guard. In some cases, a vacuum may form when mixing inside.

This negative pressure causes the cover to lock up and is difficult to remove. This is not a problem at all. All you need is a bowl big enough for a mug or a pitcher.

Fill a bowl with hot or lukewarm water. Put a cup in this hot or lukewarm water. After a few minutes, the air in the cup will begin to expand. After this procedure, you can open it easily.

When the blades are not cut or mixed

This is usually due to things that are easy to fix. Always be careful not to exceed the maximum capacity of the cup before mixing.

The maximum tax is indicated on all trophies. Always store your articles in this order or below. Another reason this can happen is because of food that can get stuck in the blades.

To fix this problem, you need to disconnect the device first. Take the cup and remove the lid. Remove the baking tray and remove any excess food that sticks to it.

Change the plate and continue mixing. Lastly, your knives need to be very blunt to do a great job now. After prolonged use, your knives will eventually lose their sharpness.

You need to replace the old blades with new ones. You can find alternatives on Amazon, including other nutrients.

Decision on how to repair a trapped conditioner bale

I believe that Nutribullet is a lifesaver and everyone should have it because making cocktails is like walking in the park.

Hope you never get caught again. Remember to avoid any kind of leakage, and if in doubt, always refer to the instruction manual for daily use. If you follow him closely, you shouldn’t have a problem. Good share !!