Fizzy. Do you love or hate it?

If you are at Heath It Camp, choosing a drink can be frustrating. Why is everything screaming?

Fortunately, I am here to tell you how you can enjoy your favorite soft drink without fizz.

to dissolve caustic soda Use folded paper towels and stir for 5 seconds. Other ways to press soda with melted ice. Take a large glass and bring the soda to a boil in the pan. Preheating the pan is best for removing large amounts of foam.

Creating Nucleus Sites

any stain of Carbon Dioxide on your glass or bottle.

Bubbles grow on depleted areas. Then he floated to the top of the soda and fled into the air. This is why you see lines of bubbles rising from random spots in soda glass.

The process of creating these bubbles is called destruction. and deficits where the middle is created.

One way to tap soda quickly is to increase the number of intervals. The more air bubbles The faster the carbon dioxide can escape.

Anything rough and hard surface is a good choice for directing nuts, sugar, tissue paper, and ice.

Mentos is a good example of this. You probably know what happens when you add mentos to soda… But I will leave this video where you do not.

(I am still obsessed with Mentos and Coke to this day. do not judge me)

Stick tissue paper into the soda.

Easy, hassle-free and personal favorite!

To make baking soda with toilet paper:

1. Pour your soda into the glass, leaving some space on top. to prevent dancing
2. Take a physical book and fold it into four points.
3. Dip a piece of paper into the soda with the opening edge at the bottom. (This means Coke can penetrate the paper and reach more surface area.) Hold it so that it does not sink to the bottom of the glass, so the soda will swell.
4. When the soda stops foaming Take out the toilet paper and taste it. Will be nice and flat!
5. Repeat the second time if there are still some bubbles left.

I had to repeat this process twice to get the actual soda. But it works well and fast. One disadvantage is that you will lose some charcoal because it is flushed down the toilet paper.

Pour soda on ice. (good for when you are in a restaurant)

by itself This method is not possible to completely acidify soda, but it does. greatly reduced bubbles, and an easy choice if you are in a restaurant or other location. Some alternatives will make it seem strange.

Throwing a drink on ice rather than adding ice to it works better because it releases some CO2.

If you have access to glossy ice, all is well. Large areas of ice in contact with soda. The faster the ice thaws.

add soda

Adding a tablespoon of sugar to your soda is a great way to set it up quickly.

Easy to make on the go because you only need a sachet of sugar.

The soft drink will boil for a few minutes. Therefore, this should be done in a bag with free space on top.

This is not my favorite method because the added sugar makes the drink very tasty. My dentist must have nightmares about this.

if you are at home You can refill the sugar again. But sugar also makes the drink taste noticeable.

heating (good for removing a lot of foam)

Pour the soda into the pan and heat on the stove.

Your soda heaters are excellent. The more soda you drink, the less carbon dioxide you have. when it warms up carbon dioxide is released faster and soda absorbs faster.

Turning soda on as hot as possible will increase the process. If you have an egg seller This is the perfect tool.

After the bubbles have settled, you can put baking soda back in the fridge to cool. Or if you are fast, 10 minutes in the freezer should do the trick.

Top tips: Hot ginger beer or collar can be very comforting if you have abdominal pain.

This is great if you are trying to separate soda from a lot of soda at once. But note that the taste will change a little. Make small steps to see if you like the taste before installing the whole collection.

Use transfers to remove bubbles.

shaking soda

This is a classic method. But if you do not do it right it can be very difficult.

You will want to use a jar or container with a thick enough cover to shake safely without the lid coming off.

It is difficult to pull out a full bottle of soda. So it works best if you have space in the bottle. Soda heaters In this way, it will be faster.

In the alert alert:

1. Let’s start with a full bottle of soda.
2. Listen to the soda briefly (1-2 shakes at first).
3. touch the outside of the bottle
4. Slowly open the lid until you hear a ‘woo’ sound.
5. Do not open the lid and wait for a few minutes for all the gas to release.
6. Press the bottle again to release more gas.
7. Close the lid and repeat until the desired dizziness has occurred.

You can increase the amount of vibration / pressure slowly. This is because the soda will become less foamy. But be careful at first to make sure you don’t get bombs.

Be careful even if you are dealing with a bottle of soft drinks.

human sugar

Turning the soda over with a spoon increases the position of the center. (the surface where the bubbles can grow) and shake the soda to release more bubbles.

If you bring the spoon hot, the soda heats up and causes the gas to release rapidly.

If you do not have a spoon with you You can use anything you are ready to drink!

pour soda several times (and higher)

1. Find a glass or cup and pour a lot of soda a few inches above the cup. Hold the cup with your bare hands because the soda can hit.
2. Soda will work more. So do not think about filling that cup. Stand 1-2 inches from the top of the cup.
3. Get another cup and repeat the process.
4. Pour the soda into the cup several times until you get the desired flatness level.

The effect of high concentration of soda releases CO2 bubbles quickly and efficiently.

lo large glass

There are two ways to lose CO2 from soda.

1. through soap bubbles
2. of soda water surface

I’ve already talked about how to incorporate bubbles. Another thing that can be done is to increase the area of ​​the collar.

The easiest way to do this is to move it into a glass with a large opening or jar. Combine this with dropping soda from high and you will have flat soda in no time.

Mix syrup with water.

From the beginning of soda it has become a power Even if you are not stupid But it is still good news.

Now lots of sweet soda syrup to choose from. And overall it sounds like a real thing.

To make Soda Flat Mix soda and non-carbonated water. Soda removes foam immediately without hard work.

It is the perfect choice for those who want a fast and easy transfer solution.

detect Store Soda on Amazon to browse through all the different elements.

If you want a real deal You can buy whole syrup at Amazon. charcoal (Food, Swimming and Regular) sprite, Pepsi, boy, mountain dew, Ata Dr., a a roaring lion Only a few brands sell their syrup.

A 5-gallon bag will give you about 30 gallons of ‘soda’ (320-ounce can 12-ounce can or 20-ounce 192-ounce bottle).

Sometimes nothing can replace the real thing!

How to brew cans of caustic soda

Soda cups are the most difficult foam movements.

It is usually on the move and has no cover that can be changed. when that opens Not all alert systems work.

You want something a little more creative.

like bubbles with straw

Take a straw and blow bubbles in the soda. Turbulence and movement will force CO2 out of the soda, causing it to evaporate.

It may look a little weird, but it’s worth it. I recommend drinking soda first to make room on the top of the can. Alternatively, you can get a permit.

If there is no suction tube Let’s go to a coffee shop and ask. Most will have a great supply.

Why Flat Soda?

Soda is very high with CO2 gas. The gases are pumped into the water at high pressure. and when the bottle / can be closed the gas will be locked

But liquids do not like to store that much gas. Once you open the bottle, CO2 will start to escape. That’s the familiar ‘WHOOSH’ thing when you open a new bottle of soda.

Carbon dioxide will continue to escape until it evaporates, leaving blue, non-carbonated soda, and even.

How long does it take for the open soda to become flat?

When you open a bottle of soda, CO2 will slowly start to leak out. If you store soda in the refrigerator This will take 2-4 days. If you leave the soda on your side, it will take 1-2 days.

The hotter the soda, the less CO2 stored. And the soda will run faster.

Please note that these are only statistics. How room soda is heated depends on many factors, such as how well the original bottle became, the age of the soda, and the size of the bottle.

Not capping the soda will speed up the process even more. If you can not wait Use one of the methods above to get the job done quickly.